Ag Leader EZ-Guide 500 Getting Started Guide - Manual (Page 64)

Setting up a controller
On a Raven controller:
Make sure that the speed input is set to Speed Radar SP2. 1.
You usually choose the speed input setting when you first calibrate the unit; the choices given in most
Raven controllers are SP1 or SP2. SP2 is the correct setting for Speed Radar inputs. For more information
on how to check this setting, refer to your variable rate controller instruction manual.
Make sure that the speed calibration value is set correctly. For the most accurate results, recalibrate the
unit to match the lightbar output. 2.
For information on how to calibrate the unit, refer to the controller instruction manual.
Note: To check the accuracy of your current settings, compare the speed value indicated on the lightbar guidance
system with that on the spray controller.
On a Midtech controller:
Make sure that the speed calibration value is set correctly. For the most accurate results, recalibrate the
unit to match the lightbar guidance system output. 1.
For information on how to calibrate the unit, refer to the controller instruction manual.
Note: To check the accuracy of your current settings, compare the speed value indicated on the lightbar guidance
system with that on the spray controller.
Recording events
The EZ−Guide 500 lightbar can record events for playback. Only use this feature if directed to by your support
provider.
Restoring the Default Lightbar Settings
You can restore all of the lightbar settings back to the factory defaults.
Select Configuration / System / Restore Defaults. The Restore Defaults screen appears.
Note: Your field information remains unchanged.
60