HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 58)

58 Managing your fabrics, switches, and ports
Figure 12 Routing tab for port-based routing policy
Displaying fabric shortest path first (FSPF) routing
The Routing tab of the Switch Admin module displays information about routing paths.
To view FSPF routing:
1. Launch the Switch Admin module as described on page 43 .
2. Click the Routing tab.
3. Perform of the following, depending on the type of switch:
• For Core Switch 2/64 and SAN Director 2/128, click a slot number under the FSPF Route category
in the navigation tree.
• For HP StorageWorks SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32, and SAN Switch
4/32, select the FSPF Route category in the navigation tree.
Configuring a static route
A static route can be assigned only when the active routing policy is port-based. When device-based or
exchange-based routing is active, you cannot disable DLS and you cannot view and configure static
routes.
When you configure a static route for a Core Switch 2/64 or a SAN Director 2/128 configured for two
logical switches, the configuration is on a logical-switch basis. This means that for each logical switch, you
must configure a static route individually.