Figure 10 ports tab, Configuring port type, To change the port type – HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class User Manual
Page 17
Fabric OS 5.0.0 Advanced Web Tools user guide
17
•
On page 52, replace
, “Ports tab,” with the following:
Figure 10
Ports tab
•
On page 17, add the following section after
Configuring port type
The Current Type column in the Ports tab indicates the current type of the port. Use the following
procedure to change the port type.
To change the port type
1.
Launch the Switch Admin module as described on page 43.
2.
Click the Ports tab and take the action appropriate to your system:
•For HP StorageWorks Core Switch 2/64 and Core Switch 2/128 directors, select the subtab
that corresponds to the correct slot for the logical switch.
•For HP StorageWorks SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32, Brocade
4Gb SAN Switch for HP p-Class BladeSystem, and SAN Switch 4/32 switches, proceed
directly to the next step.
3.
Click the number of the port you want to change.
4.
Select a port type from the corresponding Topology drop-down list.
•Allow All - allows the port to be of any type (E_Port, F_Port, or FL_Port).
•Pt-to-Pt[G-Port] - locks the port as a G_Port. The port can be either an E_Port or an F_Port.
•Loop[L-Port] - locks the port as an L_Port. The port must be an FL_Port.