HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 51)

Fabric OS 5.0.0 Advanced Web Tools user guide 51
To enable insistent domain ID mode:
1. Launch the Switch Admin module as described on page 43 .
2. Disable the switch (see ” Enabling and disabling a switch ” on page 46).
3. Click the Configure tab.
4. Click the Fabric subtab.
5. Select the Insistent Domain ID Mode check box.
6. Click Apply.
7. Enable the switch (see ” Enabling and disabling a switch ” on page 46).
Configuring FAN frame notification parameters
You can specify whether fabric access notification (FAN) frames are sent to public loop devices to notify
them of their node ID and address.
When you configure FAN frame notification parameters for the Core Switch 2/64 or SAN Director 2/128
configured with two logical switches, the configuration is on a logical-switch basis. This means that for
each logical switch, you must configure FAN frame notification parameters individually.
To configure FAN frame notification parameters:
1. Launch the Switch Admin module as described on page 43 .
2. Disable the switch (see ” Enabling and disabling a switch ” on page 46).
3. Click the Configure tab.
4. Click the Arbitrated Loop subtab.
5. Select the Send FAN Frames check box.
6. Click Apply.
7. Enable the switch (see ” Enabling and disabling a switch ” on page 46).