HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 50)

50 Managing your fabrics, switches, and ports
Figure 9 Configure tab, Fabric subtab
To configure fabric parameters:
1. Launch the Switch Admin module as described on page 43 .
2. Disable the switch (see ” Enabling and disabling a switch ” on page 46).
3. Click the Configure tab.
4. Click the Fabric subtab.
5. Make the fabric parameter configuration changes.
6. Click Apply.
7. Enable the switch (see ” Enabling and disabling a switch ” on page 46).
Enabling insistent domain ID mode
When insistent domain ID mode is enabled, the current domain setting for the switch is persistent; that is,
the same ID is requested during switch reboots, power cycles, CP failovers, firmware downloads, and
fabric reconfigurations. If the fabric does not assign the insistent domain ID, the switch segments from the
fabric.
When you enable insistent domain ID mode for the Core Switch 2/64, the configuration is on a
logical-switch basis. This means that for each logical switch, you must enable insistent domain ID mode
individually.