HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 46)

46 Managing your fabrics, switches, and ports
Figure 8 Firmware tab
Configuring a switch
Use the Switch tab of the Switch Admin module to perform basic switch configuration. Figure 6 on
page 42 shows an example of the Switch tab.
Enabling and disabling a switch
You can determine whether a switch is enabled or disabled in the Switch Admin module by looking at the
bottom right corner: the icon means that the switch is enabled, and the icon means that the switch
is disabled.
To enable or disable a switch:
1. Launch the Switch Admin module as described on page 43 .
2. Click the Switch tab.
3. Select the Enable radio button in the Switch Status section to enable the switch, or select the Disable
radio button to disable the switch.
4. Click Apply.