HP HSG Array Controller - Manual (Page 95)

Managing the Switch over the Web 5-15
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: f-ch5 Managing the Switch over the Web Last Saved On: 4/7/99 12:36 PM
If the port contains a GBIC, one of the following is shown:
■ For copper GBICs, a graphic representation of a copper GBIC with the
letters “CU”
■ For short wave fiber GBICs, a graphic representation of a GBIC with
the letters “S” and “W”
■ For long wave fiber GBICs, a graphic representation of a GBIC with the
letters “L” and “W”
■ If the port is on an arbitrated loop, the letters “F/L” are displayed in an
oval between the ports associated with the card.
If the port has failed, the port is outlined in amber to indicate a failure. The
color and flash speed of each LED, as described in Table 5-3 , indicates port
status.
Table 5-3
Port LED Status Indicators
Port LEDs Definition
No light showing No light (no module, no cable) for media interface LEDs, power not
applied for power indicator LED
Steady yellow Receiving light, but not yet online. If the port transitions to this state
while being monitored, the applet presents you with a dialog
recommending a course of action.
Slow yellow Disabled (result of diagnostics or portDisable command). Flashes
every 2 seconds. The applet presents you with a dialog
recommending a course of action.
Fast yellow Error, fault with port. Flashes every 1/2 second. The applet
presents you with a dialog recommending a course of action.
Steady green Online (connected with device over cable)
Slow green Online, but segmented (loopback cable or incompatible Switch)
flash every 2 seconds.
Fast green Internal loopback (diagnostic). Flashes every 1/2 second.
Flickering green Online and frames flowing through port.