HP HSG Array Controller - Manual (Page 208)

B-68 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
portRegTest
Figure B-45 shows theportRegTest command which is used to check
each register located on the motherboard and interface card(s) chips. Registers
are set under firmware control and are used to control the hardware route
selection and other internal hardware functions.
This command may not be executed on an operational Switch. Before issuing
portRegTest , disable the Switch using the switchDisable command
This test validates that all registers can be successfully addressed.
admin> portRegTest
Running Port Register Test .... passed.
value = 0 = 0x0
Figure B-44. portRegTest Command Example
ramTest
Figure B-46 shows the ramTest command which is used to check CPU RAM
memory. The Switch ships with 2MB of CPU RAM. This test validates proper
memory function. If this test fails, replace the memory module on the CPU
card as described in Replacing a Memory Module.
admin> ramTest
Running System DRAM Test ...... passed.
value = 0 = 0x0
Figure B-45. ramTest Command Example