HP HSG Array Controller - Manual (Page 45)

Managing the Switch 3-11
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: d-ch3 Managing the Switch Last Saved On: 4/7/99 11:59 AM
To enter an IP address:
1. Use and to increment or decrement the displayed value.
The underlined cursor indicates the numbers to modify.
When entering a number, and start in the slow mode and move
to the fast mode if the button is held down. The numbers go to a maximum of
255 and wraps to zero; for a large number, it may be faster to use the
button.
2. After entering a number, press to move the cursor to modify
the next field.
3. After setting the IP address, pressing stores the value.
Ethernet Subnetmask
Pressing , while Ethernet Subnetmask is selected, displays:
Ethernet Subnetmask
none
The default subnet mask value is none. Refer to the network administrator for
the appropriate subnet mask.
Enter the Switch’s subnet address by using and to increment or
decrement the displayed value. The numbers with the underline cursor is the
group to modify.
Fibre Channel IP Address
Pressing , while Fibre Channel IP address is selected,
displays:
Fibre Channel IP Address
0. 0. 0. 0
The default Fibre Channel IP address is 0.0.0.0 , as shown in the example.
Entering a valid non-zero IP address allows the Switch to transfer IP over the
Fibre Channel and the ability to manage all other switches connected to the
Fabric. All Switches must have ethernet IP addresses on a different subnet
than their FC IP addresses. The FC IP addresses of all Switches must be on the
same subnet.
To update the Fibre Channel’s IP address: