HP HSG Array Controller - Manual (Page 151)

Telnet Commands B-11
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
flashDefault
Figure B-9 shows the flashDefault command resets the Switch to the factory
default configuration values.
This command may not be executed on an operational Switch. You must first
disable the Switch using the switchDisable command.
admin> flashDefault
value = 0 = 0x0
Figure B-9. flashDefaultflashDefault Command Example
flashDefault also configures the Switch to boot from its flash proms
(removes any network boot parameters), erases the SNMP database, and erases
the Zoning database. If any changes have been made to the SNMP
configuration or Zoning configuration from the default values, then the factory
default does not take effect until the next reboot because the values are stored
in cache. For this reason it is recommended to always reboot the Switch
immediately after
flashDefault .
flashDefault does not change the Switches identity: WorldWide Name,
Ethernet IP address and subnetmask, gateway address, symbolic name, or
license keys.
This command should be used with care; flashDefault restores the
configurable parameters to factory default values, as follows:
■ Switch modes: tachyon, isolated, notypes, nomcast,
nopost
■ FC parameters : domain, BB_credit, RA_TOV, ED_TOV
■ FL_Port parameters: collection method, credit, FAN
frames
■ Virtual channel parameters
■ syslogd IP address
■ Fibre channel IP address and subnetmask
■ Display error level
■ OEM customizing
■ Static paths
■ Usernames and passwords