HP HSG Array Controller - Manual (Page 142)

B-2 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
General Commands
General commands allow you to control basic Switch operations.
agtcfgSet
Figure B-1 shows the agtcfgSet command which is used to set the SNMP
agent configuration to a fiber channel Switch. The fields are described in
Table B-1.
NOTE: Any change to the SNMP configuration are not shown until you reboot the Switch.
This is because SNMP polls from cache not from the flash prom so you will not be able to
see the changes
admin> agtcfgSet
Customizing MIB-II system variables ...
At each prompt, do one of the followings:
o to accept current value,
o enter the appropriate new value,
o to skip the rest of configuration, or
o to cancel any change.
To correct any input mistake:
erases the previous character,
erases the whole line,
sysDescr: [Fibre Channel Switch.]
sysLocation: [End User Premise]
sysContact: [Field Support.]
authTrapsEnabled (true, t, false, f): [false]
SNMP community and trap recipient configuration:
Community: [Secret C0de]
Trap Recipient’s IP address in dot notation: [0.0.0.0]
Community: [OrigEquipMfr]
Trap Recipient’s IP address in dot notation: [0.0.0.0]
Community: [private]
Trap Recipient’s IP address in dot notation: [0.0.0.0]
Community: [public]
Trap Recipient’s IP address in dot notation: [0.0.0.0]
Community: [common]
Trap Recipient’s IP address in dot notation: [0.0.0.0]
Community: [FibreChannel]
Trap Recipient’s IP address in dot notation: [0.0.0.0]
value = 0 = 0x0
Figure B-1. agtcfgset Command Example