HP HSG Array Controller - Manual (Page 207)

Telnet Commands B-67
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
Table B-14
portloopbackTest Command Field Descriptions
Field Description
Diagnostics Status The duration of the portLoopbackTest.
port# The port number.
diags Possible values include OK, BAD.
state Possible values include UP (active), DN (inactive).
st0-16
The tested ports. The display shows the
diagnostics frames are transmitted and received
and Low Level Interface counts (LLI_errs).
Central Memory Status The central memory status. Possible values include
OK, FAULTY.
Total Diag Frames Tx The total diagnostics frames transmitted (Tx) since
boot. This number usually corresponds to the total
frames received (Rx) but may differ because of
failure modes.
Total Diag Frames Rx The total diagnostics frames received (Rx) since
boot. This number usually corresponds to the total
frames transmitted (Tx) but may differ because of
failure modes.