HP HSG Array Controller - Manual (Page 221)

Telnet Commands B-81
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
Table B-18
interfaceShow Command Field Descriptions
Field Description
idbP The port number.
nghbP The neighbor (adjacent) Switch’s port
ifNo The port number. It should be identical to the value specified in the
command line.
cost The cost of sending a frame over the ISL connected to this port. The
value 1000 indicates a 1 Gbps link.
delay The conventional delay incurred by a frame transmitted on this ISL.
It is required by the FSPF protocol, and is a fixed value.
upCount The number of times this interface initialized (the transition number
from an offline to E_Port state).
iState The current interface state. It must be UP in order for the ISL to
forward frames to the adjacent Switch.
state The current neighbor state. Its value must be NB_ST_FULL for the
ISL to forward frames to the adjacent Switch. Other values may be
transitory, however if a value is retained for more than ten seconds,
contact Technical Support.
nghbCap Neighbor capabilities has a value of 0.
nghbId The neighbor (adjacent) Switch’s domain ID.
idbNo The port number and it should be equal to No.
remPort The port # on the remote Switch connected to this port.
nflags Internal flags for the Neighbor Finite State Machine.
initCount The number of times this Neighbor Finite State was initialized.
continued