HP HSG Array Controller User Manual
Page 27
2-8 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments: V1.6 OEM Source
Part Number: AA-RHBYA-TE 135267-001 File Name: c-ch2 Installing the Switch Last Saved On: 4/7/99 1:45 PM
IMPORTANT: These screws must be fully tightened to ensure to strength of the extended
bracket.
7.
Go to the subsection entitled Attaching the Slide Brackets to the Switch.
Attaching Mounting Brackets in a Metric Rack
You mount the Switch in this rack from the front of the rack only. Perform the
following steps:
1.
Position the mounting template against the front and rear vertical rails
(Figure 2–2), first on one side of the cabinet and then on the other side;
make sure the template is parallel from front–to–rear.
IMPORTANT: The template front should be positioned against the front rail, while the
template rear should be positioned against the rear rail.
2.
Pencil–mark the mounting bracket holes on each side of the rack with an
M.
3.
Slide a clip nut over each hole identified as a clip nut mounting hole
(Figure 2–6).
2
1
1
SHR-1390
2
Mounting bracket; Clip nut
Figure 2-6. Installing the Mounting Brackets in a Metric Rack
4.
Attach a mounting bracket to the rails on each side of the rack and
secure each bracket with 10–32x5/8 SEMS screws.
5.
Go to the subsection entitled Attaching the Slide Brackets to the Switch.