HP HSG Array Controller - Manual (Page 212)

B-72 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
diagClearError
The diagClearError command clears diagnostic errors detected on a
specified port. The command syntax is diagClearError ,
without this parameter all errors are cleared.
When you issue this command, it resets the port(s) diagnostic errors, but does
not clear the error log.
diagDisablePost
Figure B-50 shows the diagDisablePost command which disables POST
processing. The boot time without POST processing is approximately 25 ~ 30
seconds.
Compaq recommends that POST processing always be executed to ensure the
operational status of the Switch during the power on stage.
admin> diagDisablePost
Updating flash ... done.
On next reboot, POST will be skipped.
value = 0 = 0x0
Figure B-49. diagDisablePost Command Example
diagEnablePost
Figure B-51 shows the diagEnablePost command which enables POST
processing. The choice remains in effect across power cycles until toggled by
the user. The boot time with POST processing is approximately 60 ~ 65
seconds.The factory default enables POST processing.
admin> diagEnablePost
Updating flash ... done.
On next reboot, POST will be executed.
value = 0 = 0x0
Figure B-50. diagEnablePost Command Example