HP HSG Array Controller - Manual (Page 24)

Installing the Switch 2-5
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments: V1.6 OEM Source
Part Number: AA-RHBYA-TE 135267-001 File Name: c-ch2 Installing the Switch Last Saved On: 4/7/99 1:45 PM
■ Verify that all the other equipment installed in the rack has a reliable
ground connection; do not rely on connection to a branch circuit, such as
a power strip.
■ Route and support the power cord to ensure that the Switch moves
freely on the slide brackets without crimping or chafing the power cord,
or interfering with other equipment and cables installed in the rack.
Before you install the Switch in the rack you must attach mounting brackets to
the rack rails. Where you attach the mounting brackets vertically in the rack
depends on your installation, i.e., what other equipment is mounted in the rack
along with the Switch. The only tool you need is a Number 2 Phillips
screwdriver. Perform the applicable procedure from the following subsections.
Attaching Mounting Brackets in a
RETMA 41U Rack
You mount the Switch in this rack from the front of the rack only. Perform the
following steps:
1. Position the mounting template against the front and rear vertical rails
(Figure 2–2), first on one side of the cabinet and then on the other side;
make sure the template is parallel from front–to–rear.
IMPORTANT: The template front should be positioned against the front rail, while the
template rear should be positioned against the rear rail.
SHR-1384
Figure 2-2. Positioning the Mounting Template