HP HSG Array Controller - Manual (Page 177)

Telnet Commands B-37
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
admin> passwd
New username [admin]:
Old password:
New password:
Re-enter new password:
passwd: Passwords do not match; try again.
New password:
Re-enter new password:
passwd: Passwords do not match; try again.
New password:
Re-enter new password:
passwd: Number of failure attempts exceeded.
New username [user]: ^C
8. Change the user name and then finish with Ctrl-D.
admin> passwd
New username [admin]: maint
Old password: ^D
Updating flash...done.
maint>
portDisable
Figure B-23 shows the portDisable command which is used to disable a
specific port. Devices attached to a disabled port cannot communicate with the
Fabric. The command syntax is portDisable .
admin> portDisable 2
value = 0 = 0x0
Figure B-23. portDisable Command Example
NOTE: Unlike inserting a GBIC into an interface card, portDisable and portEnable do NOT
generate SNMP traps.