Milestone Basis+ 6.5 - Manual (Page 49)

Milestone XProtect Basis+ 6.5; Administrator’s Manual
Output Settings for [Device Name] [Camera
Name] Window
In the Output Settings for [Device Name] [Camera Name] window
you are able to associate a camera with particular external
outputs, defined in the I/O Setup window (see page 74), for
example the sounding of a siren or the switching on of lights.
The associated outputs can be triggered automatically when
motion is detected as well as manually through output buttons
available in the Remote Client and Smart Client (see page 140).
You access the Output Settings for [Device Name] [Camera Name]
window from the Camera Settings for [Device Name] [Camera
Name] window (see page 39), by clicking the Outputs... button.
Associating Outputs with Manual Control and Detected
Motion
Note: Use of features in the Output Settings for [Device Name] [Camera Name] window requires
that output has been defined in the I/O Setup window (see page 74).
You have a high degree of flexibility when associating a camera with particular outputs:
• You are able to select between all available outputs, i.e. outputs defined as output events
for the camera itself as well as outputs defined as output events for other devices on the
XProtect Basis+ system
• The same output may be used for manual control through an output button as well as for
automatic triggering when motion is detected
Selecting Output for Manual Control
You are able to specify outputs to be triggered manually from a list in the Remote Client or Smart
Client (see page 140).
To specify an output for manual triggering in the Remote Client/Smart Client, do the following:
1. Select the required output in the All Outputs list in the left side of the Output Settings for
[Device Name] [Camera Name] window.
Tip: When you select an output in the All Outputs list, you can view detailed
information about the selected output under Output Information in the lower part of the
window.
2. Click the >> button located between the All Outputs list and the On Manual Control list.
This will copy the selected output to the On Manual Control list.
An unlimited number of outputs may be selected this way.
You are able to determine each output’s position in the Remote Client’s and Smart Client’s output
list by moving the selected output up or down in the On Manual Control list with the up and down
buttons located to the right of the list. The selected output is moved up one step each time you
click the up button. Likewise, each time you click the down button, the selected output is moved
down one step.
www.milestonesys.com Page 49 Camera Administration