Spectra Precision ProMark 800 Reference Manual User Manual
Page 6
ii
Chapter 7. Miscellaneous .............................................................. 111
ATOM File Naming Conventions...............................................111
Reverting to V1 for All ATOM Messages Generated by the Receiver111
Time-tagged RTK vs. FAST RTK Position Output ......................112
Special Button Combinations Summary ....................................112
Reset Procedure ...................................................................113
Using a USB key to Save/Upload Receiver Configurations or
Copy User Data ......................................................................113
Asking a Rover to Use the Same Local Coordinate System
as the Base............................................................................116
Firmware Upgrade Procedure...................................................117
Changing the Radio Module or Using One for the First Time .......120
Direct IP Connection To Your Own Base Through GPRS Modem
and RTDS Software ................................................................121
Default Settings .....................................................................124
ProMark 800 Serial Commands & Data Outputs Supplement ........... 131
Appendix A. Using Serial Commands .............................................. 133
Introduction to Serial Commands .............................................133
Applying Commands Through Bluetooth or a Serial Port .............134
Running Serial Commands from a USB Key ..............................136
List of Commands ..................................................................138
Appendix B. Set Command Library ................................................. 143
AGB: Enabling/Disabling GLONASS Bias Adjustments ...............143
ANH: Antenna Height .............................................................144
ANP,PCO & ANP,EDx: Creating/Editing Antenna Definitions .......144
ANP,DEL: Delete User-Defined Antenna ...................................146
ANP,OUT: Defining a Virtual Antenna.......................................146
ANP,REF: Naming the Antenna Used at the Base ......................147
ANR: Antenna Reduction Mode ...............................................148
ANT: Antenna Height..............................................................149
ATL: Debug Data Recording.....................................................152
ATM: Enabling/Disabling ATOM Messages ................................153
ATM,ALL: Disabling All ATOM Messages...................................155
ATM,PER: Setting Unique Output Rate for all ATOM Messages ...156
ATM,VER: Setting the Version of ATOM Messages .....................156
BAS: Differential Data Type.....................................................157
BEEP: Beeper Setup...............................................................159
BRD: Enabling/Disabling the RTC Bridge Function ....................159
BTH,NAME: Bluetooth Device Name ........................................162
BTH,PIN: Bluetooth Device Pin Code .......................................163
CFG: GNSS Tracking Configuration ..........................................164
CMD,LOD: Running a List of $PASH Commands .......................166
CMD,WTI: Inserting Wait Times ...............................................167
CMR,TYP: CMR Message Type and Rate ...................................168