Spectra Precision ProMark 800 Reference Manual - Manual (Page 258)

246
Set Command Library
$PASHS,SOMM,WRN
SOM,WRN: Channel Warnings Mask
Function This command is used to mask the signal observations for
those signals flagged with channel warnings (MPC warning
bits are counted from 1 to 8). This means that only the
observations from non-flagged signals will be output (all the
others will be rejected).
This mask is enabled only after the “User-defined” option (9)
has been selected with the $PASHS,SOM command.
Command Format Syntax
$PASHS,SOM,WRN,s1[,s2][*cc]
Parameters
Comments
• A signal is considered as flagged in at least one of the
following cases:
– Carrier phase tracking is not stable (Bit 3 of MPC/MCA
warning is set).
– Pseudo-range data quality is bad (Bit 5 of MPC/MCA
warning is set).
– Polarity is not resolved (MPC/MCA Phase Tracking
Polarity flag is set to 0).
• The $PASHS,SOM,WRN command will mask only some
particular signal data (e.g. L1CA or L2P) corresponding to
a given satellite. If at the same time the L1CA data are
disabled, then ALL the satellite observations, and not only
those masked, will be rejected.
Parameter Description Range Default
s1 Differential data mask ON, OFF ON
s2
Raw data mask. If s2 is omitted, then the
receiver will assume s2=s1
ON, OFF OFF
*cc Optional checksum *00-*FF
Raw Data Masked by s2 Differential Data Masked by s1
MPC
DPC
ATM,MES
ATM,RNX,SCN,0
All other messages