Spectra Precision ProMark 800 Reference Manual - Manual (Page 172)

160
Set Command Library
Parameters
Examples
Enabling RTC Bridge in the receiver by forwarding RTK
corrections from the modem to its port A (to which the
license-free radio transmitter is connected):
$PASHS,BRD,ON,0,E,A*14
Disabling RTC Bridge by preventing RTK corrections from
being forwarded to the output port:
$PASHS,BRD,OFF*42
Comments • To receive data, the $PASHS,NTR,.. and $PASHS,DIP
commands should be used.
• If the data needs to be sent to an external UHF
transmitter, the $PASHS,RDP command should be used
to configure the transmitter.
• The d2 parameter is taken into account only if the
Automatic mode is selected for the choice of differential
data inputs (see $PASHS,CPD,REM).
Relevant Query
Command
$PASHQ,BRD
See also $PASHS,NTR,..
$PASHS,DIP
$PASHS,RDP,TYP
$PASHS,RDP,PAR
Parameter Description Range Default
s1
Controls the availability of RTK corrections
on the specified output port:
• OFF: No RTK corrections forwarded to
the output port.
• ON: RTK corrections forwarded to the
output port.
ON, OFF OFF
d2
Enables or disables the use of RTK correc-
tions in the receiver’s position computation.
• 0: RTK corrections used
• 1: RTK corrections not used
0, 1 0
c3
Input port ID (port from which RTK correc-
tions are available in the receiver).
E (modem) E
c4
Output port ID (serial port to which the
licence-free radio transmitter is con-
nected).
A A
*cc Optional checksum *00-*FF