Spectra Precision ProMark 800 Reference Manual - Manual (Page 286)

274
Query Command Library
Parameters
Example $PASHQ,CFG
$PASHR,CFG,DSL*1D
See Also $PASHS,CFG
CMR,MSI: CMR Message Status
Function This command is used in a base receiver to read the current
settings of the CMR messages the base currently generates
and outputs.
Command Format Syntax
$PASHQ,CMR,MSI[*cc]
Response Format Syntax
$PASHR,CMR,MSI,d1,d2,d3,d4,d5,d6,d7,d8,d9*cc
Parameters
Parameter Description Range
s1
GNSS tracking currently enabled:
• SSL: Single-signal tracking
• DSL: Dual-signal tracking
• TSL: Triple-signal tracking
SSL, DSL, TSL
*cc Checksum
Parameter Description Range
d1 Number of CMR messages currently output 4
d2 Message type “0” label 0
d3 Message type “0” output rate, in seconds 0-300
d4 Message type “1” label 1
d5 Message type “1” output rate, in seconds 0-300
d6 Message type “2” label 2
d7 Message type “2” output rate, in seconds 0-300
d8 Message type “3” label 3
d9 Message type “3” output rate, in seconds 0-300
*cc Checksum *00-*FF