Spectra Precision ProMark 800 Reference Manual - Manual (Page 161)

149
Set Command Library
Parameters
Example
Setting the antenna reduction mode to ON:
$PASHS,ANR,ON*05
Relevant Query
Command
$PASHQ,ANR
See also $PASHS,ANH
$PASHS,ANT
ANT: Antenna Height
Function This command is used to define the antenna height,
especially when it was determined using the slant
measurement method. However, a vertical measurement can
also be entered through this command.
Using the $PASHS,ANT command overwrites all previous
settings performed with the $PASHS,ANH command.
Parameter Description Range
s1
Antenna reduction mode:
• OFF: No antenna reduction. The receiver ignores
the antenna parameters entered via $PASHS,
ANH or $PASHS,ANT. The computed position is
that of the antenna’s L1 phase center. This
implies that the entered position for the base
should also be that of its antenna’s L1 phase cen-
ter
• ON: Antenna reduction is active (default). From
the parameters entered through the $PASHS,
ANH or $PASHS,ANT command, the position
computed for the L1 phase center is projected to
the ground thus making this point (ground mark)
the real location of the rover. This implies that the
entered position for the base should also be that
of its ground mark.
• ARP: The receiver ignores the antenna parame-
ters entered via $PASHS,ANH or $PASHS,ANT.
The computed position represents the location of
the ARP. This implies that the entered position for
the base should also be that of its antenna’s ARP.
OFF, ON,
ARP
*cc Optional checksum *00-*FF