Spectra Precision ProMark 800 Reference Manual - Manual (Page 125)

113
Miscellaneous
Reset Procedure
The receiver may be reset to the default settings using the
Log+Scroll+Power button combination. Release the three
buttons only after the logo is displayed.
The reset procedure is also used to poll the radio module. If
a new module is detected, the receiver will update its
database so it can successfully communicate with the new
module.
The default settings can also be restored using the
$PASHS,INI command. With this command, you can ask
more than a simple “restore default settings”. See INI:
Receiver Initialization on page 191.
Using a USB key to Save/Upload Receiver Configurations or
Copy User Data
Generally speaking, after connecting a USB key to the
receiver, the USB logo will appear on the screen after a while.
Then three different screens (or less, depending on the
content of the USB key) will be shown in succession, at a rate
of 10 seconds, provided no button is pressed in the
meantime. These three possible screens are shown below.
USB Port
ProMark 800
Cable P/N 702104
USB Key