Spectra Precision ProMark 800 Reference Manual - Manual (Page 243)

231
Set Command Library
Examples
Setting the internal Pac Crest radio receiver:
$PASHS,RDP,PAR,D,PDL,2,AUT,0,9600,LOW,0,0*75
Setting the internal U-Link Rx:
$PASHS,RDP,PAR,D,MDL,0,AUT,0,9600,LOW*6A
Setting the external U-Link TRx:
$PASHS,RDP,PAR,A,MDL,1*45
Relevant Query
Command
$PASHQ,RDP,PAR
See also $PASHS,RDP,ON
$PASHS,RDP,OFF
$PASHS,RDP,TYP
$PASHQ,RDP, CHT
RDP,TYP: Defining the Type of Radio and the Receiver Port Used
Function This command is used to set manually the type of radio
connected to the specified port. Normally, the type of internal
radio (typically connected to port D) is detected
automatically.
If you change physically the internal radio of the receiver, you
may send command $PASHS,RDP,TYP,D,UNKNOWN or reset
the receiver configuration so that the receiver can detect
automatically the new internal radio.
Command Format Syntax
$PASHS,RDP,TYP,c1,s2[*cc]