Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 99)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 85
53-1001945-01
show
2
Parameters
ap Status of adopted access port.
•
<1-48> – The index of the access port.
•
AA-BB-CC-DD-EE-FF – The MAC address of a access port.
ap-detection-config Detected AP configuration parameters.
ap-images Lists the access port images on the switch.
ap-unadopted Lists unadopted access ports.
approved-aps Approved APs seen by access port scans.
channel-power List of available channel and power levels for a radio.
•
11a – Radio is 802.11a.
•
indoor – Radio is placed indoors.
•
outdoor – Radio is placed outdoors.
•
11b – Radio is 802.11b.
•
indoor – Radio is placed indoors.
•
outdoor – Radio is placed outdoors.
•
11bg – Radio is 802.11bg.
•
indoor – Radio is placed indoors.
•
outdoor – Radio is placed outdoors.
config Wireless configuration parameters.
country-code-list List of supported country names and 2 letter IS0 3166 codes.
default-ap Information for default access-port.
hotspot-config <1-32> WLAN hotspot configuration.
mac-auth-local List out the mac-auth-local entries.
•
<1-1000> – Displays mac-auth-local entry.
mobile-unit Details of associated mobile unit.
•
<1-8192> – Index of mobile unit.
•
AA-BB-CC-DD-EE-FF – MAC address of mobile unit.
•
association-history – Displays mobile unit history. Enter the
mobile unit MAC address in AA-BB-CC-DD-EE-FF format.
•
probe-history ( ) – Displays MU probe-history.
•
<1-200> – Index to display probe-logging.
•
config-list – List probe history MAC addresses.
•
radio <1-4096> – Show mobile units associated with this radio.
•
statistics – Mobile unit rf statistics.
•
wlan – Shows mobile units associated to this WLAN.
multicast-packet-limit Multicast packet limit.
qos-mapping Quality of Service mappings used for mapping WMM access categories and 802.1p
/ DSCP tags.
•
wired-to-wireless – Mappings used when traffic is switched from wired to the
wireless side.
•
wireless-to-wired – Mappings used when traffic is switched from wireless to the
wired side.