Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 503
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
489
53-1001945-01
Wireless Configuration Commands
20
ap
Wireless Configuration Commands
Use this command to define the name and location of the access port.
Syntax
ap [|
aap-mgmt-vlan|aap-native-vlan-id|aap-native-vlan-tag|adoption-policy|
country-code|lan-acl|location|name|radio-config]
Parameters
Example
RFS7000(config-wireless)#ap 00-15-70-14-FE-C4 location 5th Floor SalesUnit
RFS7000(config-wireless)#
AP Index<1-1024>
A single AP index. Use
show wireless ap
command to view the AP’s index
value.
•
ABG-scan (enable) – Configures the ABG scan mode on the ap.
•
enable – Allows detector radio to do ABG scan.
•
aap-admin-passwd (LINE) – Configures the aap admin password.
•
LINE – Specify the password that is 8 to 11 characters long.
•
aap-mgmt-vlan (lan1 <1-4094>)– Configures the aap mgmt vlan.
•
lan1 – Lan interface LAN1 with the index value <1-4094>.
•
aap-native-vlan-id (lan1 <1-4094>) – Configures native vlan id.
•
lan1 – Lan interface LAN1 with the index value <1-4094>
•
aap-native-vlan-tag <1-2> (tagged|untagged) – Configures native vlan tag.
•
<1-2> – Lan interface1: LAN 1, 2: LAN2
•
tagged – Specifies as tagged.
•
untagged – Specifies as untagged.
•
adoption-policy (allow|deny)– Specifies adoption policy.
•
allow –Allows adoption.
•
deny – Denies adoption.
•
country-code (WORD)– Configures the country of operation. Resets the
regulatory configuration (channels, self-healing offset) of all radios.
•
WORD – The two letter ISO-3166 country code. Use the
show
wireless country-coded-list
to see the list of supported
countries.
•
lan-acl – Applies an ACL on LAN port for aap.
•
location – Configures the ap-location description for this ap.
•
name – Configures the ap-name description for this ap.
•
radio-config – Sets radio configuration.
The above parameters can be used with the LIST and MAC Address values.
LIST
A list or range of AP indices. Use
show wireless ap
command to view the AP’s
index value.
MAC Address
AP’s MAC address. Use
show wireless ap
command to view the AP’s index
value.