Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 149)

Brocade Mobility RFS7000-GR CLI Reference Guide 135
53-1001945-01
Priv Exec Command
4
copy
Priv Exec Command
Use this command to copy any file (config, log, txt ...etc) to and from the switch.
NOTE
Copying a new config file onto an existing running-config file merges it with the
existing running-config. Both, the existing running-config and the new config file are applied as the
current running-config of the switch.
Copying a new config file onto a start-up config file replaces the existing start-up config file with the
parameters of the new config file. It is always better to erase the existing start-up file from the switch
and then copy the new config to the startup config.
Syntax
copy (FILE|URL) (FILE|URL)
Parameters
Example
RFS7000#copy ?
FILE File from which to copy
Files: flash:/path/file
nvram:startup-config
system:running-config
URL URL from which to copy
URLs: sftp://@/path/file
RFS7000#copy
Transferring file snmpd.log to remote tftp server?
RFS7000#copy flash:/log/snmpd.log
tftp://157.235.208.105:/snmpd.log
Accessing running-config file from remote tftp server into switchrunning-config?
RFS7000#copy tftp://157.235.208.105:/running-
config running-config
FILE Target file from which to copy. Select from:
•
flash:/path/file
•
nvram:startup-config
•
system:running-config
URL The target URL from which to copy. Select from:
•
sftp://@/path/file