Wips – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 557

Brocade Mobility RFS7000-GR Controller CLI Reference Guide
543
53-1001945-01
Wireless Configuration Commands
20
wips
Wireless Configuration Commands
Use this command to configure parameters related to WIPS.
Syntax
wips [detect-window|disable|event|reset-to-default]
wips detect-window <5-300>
wips event [80211-replay-check-failure|ad-hoc-advertising-authorized-ssid|
ad-hoc-network-violation-authorized-device|
ad-hoc-network-violation-unauthorized-device|aggressive-scanning|all|
ap-default-configuration|ap-ssid-broadcast-in-beacon|
crackable-wep-iv-key-used |decryption-failures|
dos-association-or-authentication-flood|
dos-broadcast-deauthentication|dos-eapol-start-storm|
dos-unicast-deauthentication-or-disassociation|eap-flood|eap-nak-flood|
failures-reported-by-authentication-servers|fake-ap-flood|
frames-from-unassociated-stations|frames-with-bad-essids|
fuzzing-all-zero-mac-address-observed|fuzzing-invalid-frame-type-detected|
fuzzing-invalid-management-frame|fuzzing-invalid-sequence-number|
identical-source-and-destination-addresses|impersonation-attack-detected|
invalid-8021x-frames| non-changing-wep-iv|replay-injection-attack|
tkip-mic-counter-measures-caused-by-station|
transmitting-device-using-invalid-mac|
unauthorized-ap-using-authorized-ssidunencrypted-station-transmission-detect
ed]
Parameters
detect-window <5-300>
Sets the number of seconds for which information is collected before analysis.All the
thresholds are function of this window size.
disable
Disables WIPS without affecting the configuration.