Wireless instance, In this chapter, Wireless configuration commands – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 497: 20 wireless instance, Chapter 20, “wireless instance, Chapter
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
483
53-1001945-01
Chapter
20
Wireless Instance
In this chapter
•
Wireless Configuration Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 483
Use the
(config-wireless)
instance to configure wireless parameters.
Wireless Configuration Commands
The following table summarizes the Global Config commands.
TABLE 17
Wireless configuration commands
Command
Description
Ref.
Invokes AAP related commands.
Use this command to disable admission control across all radios.
Adopts a radio even if not configured. The default templates are used for
configuration.
Defines a preference identifier for the switch. All radios configured with this
identifier are more likely to be adopted by this switch.
IEnvokesinvokes AP related commands to define the name and location of
the AP.
Invokes Rogue AP Containment commands.
Access port detection configuration commands.
Modifies static IP information for access ports.
Reverts the number of attempts after which the standby switch adopts its
default value 11.
Changes the default inactivity timeout for access-port.
Specifies a list from which channels can be picked.
Sets the rate at which broadcast and multicast traffic is transmitted.
Clears the display screen.
Change settings for cluster master support, required for cluster-level
functioning.
Configures the country of operation. Regulatory configuration (channels,
self healing offset) of all configured radios is reset to default values.
Initiates debugging functions.
Forwards broadcast DHCP responses to one portal when the destination
mobile-unit is known from the response contient.