Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 506)

492 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
ap-ip
Wireless Configuration Commands
Use this command to modify the static IP address for access port.
Syntax
ap-ip [|default-ap]
ap-ip [static-ip|switch-ip]
ap-ip (static-ip)
IPA.B.C.D/M>
ap-ip (switch-ip)
[add |delete(|
addressA.B.C.D>)|set-default]
ap-ip (default-ap) [add |delete(|)|
set-default]
Parameters
Example
RFS7000(config-wireless)#ap-ip 1 static-ip 192.168.10.25/24 192.168.10.1
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-ip 1 switch-ip add 192.168.10.25 10.10.1.4
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-ip default-ap switch-ip set-default
RFS7000(config-wireless)#
/ MAC
addressLIST> Use show wireless ap to view the AP’s index or MAC address. Select the AP’s
index / MAC Address to modify its static IP address.
•
static-ip – Static IP address, netmask and gateway address of the AP.
•
A.B.C.D/M – Static IP address and mask.
•
A.B.C.D – Gateway IP address.
•
switch-ip – Static switch IP address.
•
add – Add static switch IP addresses.
•
delete [<1-12> |A.B.C.D] – Delete static switch IP address.
•
set-default – Default switch IP addresses.
•
LINE – Space separated list of static switch IP addresses.
•
<1-12> – A single switch IP address index.
•
A.B.C.D – IP address.
default-ap Default static switch ip addresses.
•
switch-ip – Static switch IP address.
•
add – Add static switch IP addresses.
•
delete [<1-12> |A.B.C.D]– Delete static switch IP address.
•
set-default – Default switch IP addresses.