Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 418)

404 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
bootfile
DHCP Config Commands
Use this command to assign a bootfile name for the DHCP configuration on the network pool.
Syntax
bootfile
Parameters
Usage Guidelines
Use the
bootfile
command to specify the boot image. The boot file contains the boot image name
used for booting the bootp clients (DHCP clients). Only one boot file is allowed per pool.
Use
[no] bootfile
command to remove the bootfile. Do not use the with the
bootfile command as only one bootfile exists per pool. The command
[no] bootfile
will remove
the existing command from the pool.
Example
RFS7000(config-dhcp)#bootfile bootexample.txt
RFS7000(config-dhcp)#
bootfile Indicates the boot image for bootp clients. The file name can contain letters,
numbers, dots and hyphens. Consecutive dots and hyphens are not permitted.