Speed – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 345
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
331
53-1001945-01
Interface Config commands
12
speed
Use this command to specify the speed of a fast-ethernet (10/100) or a gigabit-ethernet port
(10/100/1000).
Syntax
speed(10|100|1000|auto)
Parameters
Usage Guidelines
Set the interface speed to
auto
to detect and use the fastest speed avaiable. The speed detection
is based on the connected network hardware.
Example
RFS7000(config-if)#speed auto
RFS7000(config-if)#
RFS7000(config-if)#speed 1000
RFS7000(config-if)#
RFS7000(config-if)#show interfaces ge2
Interface ge2
Hardware Type Ethernet, Interface Mode Layer 2, address is 00-15-70-37-fb-73
index=2002, metric=1, mtu=1500, (HAL-IF)
Speed: Admin 1G, Operational Unknown, Maximum 1G
Duplex: Admin Auto, Operational Unknown
Active Medium: Unknown
Switchport Settings: Mode: Access, Access Vlan: 1
input packets 0, bytes 0, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0, missed 0
output packets 767, bytes 144486, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0, window 0
RFS7000(config-if)#
10
Forces 10 Mbps operation. The port runs at 10 Mbps.
100
Forces 100 Mbps operation.The port runs at 100 Mbps.
1000
Forces 1000 Mbps operation.The port runs at 1000 Mbps.
auto
Enables AUTO speed configuration.The port automatically detects the speed it
should run based on the port at the other end of the link.