Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 539)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 525
53-1001945-01
Wireless Configuration Commands
20
Parameters
<1-4096> A single radio index.
admission-control (voice) Admission control parameters.
•
voice – voice parameters.
•
max-mus <0-256> – Maximum mobile units to be admitted.The
maximum value range is <0-256>.
•
max-perc <0-100>– Maximum percentage of air time allocated to voice
traffic.The maximum percentage is 100.
•
max-roamed-mus <0-256> – The maximum roamed mobile units to be
admitted.
•
res-roam-perc – The percentage of air time allocated exclusively for
roamed mobile-unit.This value <0-100> is calculated relative to the
configured max air time percentage allocated for voice.
adoption-policy [allow|deny] Specifies adoption policy.
•
allow – Allows adoption
•
deny – Denies adoption.
adoption-pref-id <0-65535> A preference identifier for this radio. The radio is more likely to be adopted by a
preferred switch.
NOTE: A Brocade Mobility 7131N-FGR has two radio’s. Configuring any one radio
as a pref-id ensures the other radio is also configured with this pref-id.
A Brocade Mobility 7131N-FGR cannot be adopted by two switches
simultaneously.
ampdu MAC protocol frames.
•
min-spacing – Specifies the spacing between received MPDUs. The values
are as follows:
•
.25 microsec
•
.5 microsec
•
0 microsec
•
1 microsec
•
2 microsec
•
4 microsec
•
8 microsec
•
rx-limit –Specifies Receive buffer limit. The values are as follows:
•
16382 bytes
•
32767 bytes
•
65535 bytes
•
8191 bytes
•
tx-enable [min-spacing|rx-limit|tx-limit] – Enables Transmit A-MPDU.
•
tx-limit <0-65535> – Transmit Buffer Limit of value <0-65535>.
antenna-mode
ndary> Antenna diversity mode. Select from the following options:
•
diversity–Full diversity (both antennas).
•
mimo – MIMO
•
primary–Primary antenna only.
•
secondary–Secondary antenna only.
base-bridge
[enable|max-clients] Base bridge settings.
•
enable – Enables base bridge.
•
max-clients <0-12> – Maximum client bridges allowed.
beacon-interval <50-200> Beacon interval in K-uSec.
bridge-fwd-delay<4-30> STP Bridge Forward Delay time in seconds.