Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 573)

Brocade Mobility RFS7000-GR CLI Reference Guide 559
53-1001945-01
Chapter
21
RTLS Instance
In this chapter
• RTLS Config Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 559
Use the
(config-rtls)
instance to configure Real Time Location System (RTLS) parameters.
To navigate to this instance, use the command
RFSwitch(config)#rtls
RFSwitch(config-rtls)#
RTLS Config Commands
The following table summarizes
config-rtls
commands:
TABLE 18 RTLS Configuration commands summary
Command Description Ref.
aeroscout Configures aeroscout parameters page 560
ap Configures AP specific RTLS parameters page 561
clrscr Clears display window page 563
end Ends the current mode and moves to EXEC mode page 564
exit Ends current mode and moves to the previous mode page 565
help Description of the interactive help system page 566
ekahau Configures ekahau parameters page 567
no Negates a command or sets its defaults page 568
service Invokes service commands to troubleshoot or debug
(config-rtls) instance configurations
page 571
show Displays the running system information page 573
site Configures site parameters page 575
sole Configures Smart Opportunistic Location Engine (SOLE)
parameters page 576
switch Configures switch parameters page 577