Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 69
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
55
53-1001945-01
show
2
Standard IP access list 20
mark 8021p 5 any rule-precedence 10
RFS7000(config)#
RFS7000(config)# show ip access-list
Standard IP access list 1
permit 172.16.10.10/24 rule-precedence 10
RFS7000(config)#
RFS7000#show ip dhcp binding
IP MAC/Client-Id Type Expiry Time
-- ------------- ---- -----------
RFS7000(config)#show ip dhcp binding
IP MAC/Client-Id Type Expiry Time
-- ------------- ---- -----------
RFS7000(config)#
RFS7000#show ip dhcp pool
!
ip dhcp pool pl
!
ip dhcp pool pool1
domain-name test.com
bootfile 123
network 10.10.10.0/24
address range 10.10.10.2 10.10.10.30
!
ip dhcp pool poo110
next-server 1.1.1.1
netbios-node-type b-node
RFS7000#show ip dhcp-vendor-options
Server Info:
Firmware Image File:
Config File:
Cluster Config File:
RFS7000#show ip domain-name
IP domain-lookup : Enable
Domain Name : Brocade.com
RFS7000#show ip http server
HTTP server: Running
Config status: Enabled
RFS7000#show ip http secure-server
HTTP secure server: Running
Config status: Enabled
Trustpoint: default-trustpoint
RFS7000(config)#show ip nat translations outside source
S/D Dir Actual Address NATed Address ACL Overload-If
RFS7000(config)#
RFS7000#show ip routing
IP routing is on
RFS7000(config)#show ip route detail
Codes: K - kernel/icmp, C - connected, S - static, D - DHCP
> - Active route, - Next-hop in FIB, p - stale info