Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 309)

Brocade Mobility RFS7000-GR CLI Reference Guide 295
53-1001945-01
Chapter
11
Crypto-trustpoint Instance
In this chapter
• Trustpoint Config commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 295
Use the
config-trustpoint
commands to define a Certificate Authority (CA) trustpoint.
Use
crypto-pki-trustpoint
to instantiate
crypto-trustpoint
instance.
Trustpoint Config commands
The following table summarizes the
config-crypto-trustpoint
commands.
TABLE 8 Trustpoint config commands
Command Description Ref.
clrscr Clears the display screen. page 296
company-name Company name (applicable only for request). page 297
email Email ID. page 298
end Ends the current mode and moves to the EXEC mode. page 299
exit Ends the current mode and moves to the previous mode. page 300
fqdn Domain name configuration. page 301
help Describes the interactive help system. page 302
ip-address Configures Internet Protocol (IP) address. page 303
no Negates a command or set defaults. page 304
password Challenge password (appplicable only by request). page 305
rsakeypair Rsa Keypair to associate with the trustpoint. page 306
service Displays service commands. page 307
show Shows the running system information. page 308
subject-name Subject name is a collection of required parameters to configure a
trustpoint. It consists of the common_name, country, state, organization,
org, name, etc. page 310