Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 335)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 321
53-1001945-01
Interface Config commands
12
management
Interface Config commands
Use this command to configure the selected interface as the management interface. It can only be
used on a VLANx interface. The tftp/ftp server, which provides the switch its config file at startup,
must be accessible via this interface.
VLAN 1 is by default the management interface for the Brocade Mobility RFS7000-GR Controller.
Syntax
management
Parameters
None.
Usage Guidelines
Management privilage can be set only on a L3 interface. Use this command along with the
(config) management secure
in config mode. This ensures switch management access is
restricted to the management VLAN only.
Refer management on page 204 for
(config) management secure
configuration.
Example
RFS7000(config)#interface vlan 1000
RFS7000(config-if)#management
RFS7000(config-if)#