Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 332)

318 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Interface Config commands
12
ip
Interface Config commands
Use this command to configure an IP address for the assigned Ethernet, VLAN or tunnel.
Syntax
ip(access-group|address|helper-address|nat)
ip access-group( <1-99>|<100-199>|<1300-1999>|<2000-2699>)in
ip address(A.B.C.D/M|dhcp)
ip address(A.B.C.D/M) (secondary)
ip helper-address A.B.C.D
ip nat(inside|outside)
Parameters
Usage Guidelines
IPv4 commands are not allowed on a L2 interface. Use the
ip access-group
command to attach
an access list to an interface. Use the
no ip access-group
command to remove the access list
from the interface.
Use
mac access-group
to atach a MAC access list to an interface.
Use the
[no] ip [options]
command to undo all the above ip based interface configurations.
Example
RFS7000(config-if)#ip access-group 110 in
access-group Access group.
•
(<1-99> |<100-199>) – IP extended access list.
•
(<1300-1999>|<2000-2699>) – IP extended access list (expanded range).
•
WORD – Access list name.
•
in – Incoming packets.
address Sets a static IP address and network mask of a layer 3 SVI (Switch Virtual
Interface).
•
A.B.C.D/M – IP address (for example, 10.0.0.1/8).
•
secondary – The secondary IP address.
•
dhcp – Uses a DHCP Client to obtain an IP address for the interface. This
enables DHCP on a layer 3 SVI.
arp [rate-limit
|trust] arp
•
rate-limit <1-1000000> – Does packet ratelimiting at the rate of <1-
1000000> packets per second.
•
trust – Trust state coming for arp responses in this interface.
dhcp (trust) dhcp
•
trust – Trust state coming for dhcp responses in this interface.
helper-address Forwards DHCP and BOOTP packets.
•
A.B.C.D – IP to which DHCP and BOOTP packets are forwarded.
nat Network Address Translation (NAT).
•
inside – Inside interface.
•
outside – Outside interface.