Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 563)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 549
53-1001945-01
Wireless Configuration Commands
20
Parameters
[ <1-256> | WLAN] Select a single WLAN index. You also have the option of selecting a list (1,3,7) or
range (3-7) of WLAN indices.
80211-extensions
(move-command) (enable) Enables support for extensions to 802.11.
•
move-command – Enables support for the move-command (fast roaming).
•
enable – Enables the 802.11 extension.
80211w-pmf
[optional|required|sa-query] 802.11w Protected Management Frames setting.
•
optional – MFP optional.
•
required – MFP required.
•
sa-query [max-timeout <100-6000>|retry-timeout <10-1500>]– SA Query
Protocol settings
•
max-time<100-6000> – maximumm timeout in milliseconds.
•
retry-timeout <10-1500> – retry timeout in millicseconds.
aap-proxy-radius (enable) Configures proxying AAP radius requests.
•
enable (realm strip) – Enables proxying AAP radius requests.
•
realm – Choose realm name
•
strip – Strip realm name while proxying requests.
accounting
(none|radius|syslog) Accounting on this WLAN.
•
none – No accounting on this WLAN.
•
radius – Uses RADIUS accounting on this WLAN.
•
syslog – Uses syslog accounting on this WLAN.
acl
(exceed-rate)(mu-denied-traffic)
<0-1000000>
(disassociate) Actions taken based on ACL configuration .
•
exceed-rate – Actions to be taken when a rate is exceeded.
•
mu-denied-traffic – When the event is disallowed traffic from the MU.
•
<0-1000000> – Allowed rate threshold of disallowed MU traffic in
packets/sec.
•
disassociate – Enables/Disables disassociate
add-vlan [<1-4094>|VLAN]
(limit) <0-8192> Instead of starting a new VLAN assignment for the given WLAN, this command
adds a VLAN assignment to the existing VLAN assignment. All prior VLAN settings
will be retained.
•
[<1-4094>|VLAN] – VLAN range list. It can be either a single index or a list
(eg: 1,3,7) or range (eg: 3-7) of indices.
•
limit <0-8192>– Sets user limits on VLANs for this WLAN.
NOTE: The [no] form of add-vlan command will delete the specified VLAN
mapping, iterating over the specified WLAN range list.
If the specified VLAN mapping does not exist for particular WLAN, a
warning “specified VLAN does not exists” displays.
The delete action continues on the remaining VLANs. If all VLANs are
deleted. A default VLAN assignment occurs.
answer-bcast-ess Allows this WLAN to respond to probes for broadcast ESS.
authentication-type
(eap|hotspot|mac-auth) The authentication type of this WLAN.
•
eap – EAP authentication (802.1X).
•
hotspot – Web based authentication.
•
mac-auth – MAC authentication (RADIUS lookup of MAC address).
(client-bridge-backhaul)(enable) Client bridge backhaul capability on this wlan.
•
enable – Enables this capability.
deny-static-mu Drop packets from static Mobile Units .
description The description of this WLAN.