Interfaces – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 64
50
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
show
2
interfaces
Common to all modes
Syntax
show interfaces [
switchport(
Parameters
Example
RFS7000(config)#show interfaces ge 1
Interface ge1 is UP
Hardware-type: Ethernet, Mode: Layer 2, Address: 00-15-70-38-08-43
Index: 2001, Metric: 1, MTU: 1500, Status-flags: AST> Speed: Admin Auto, Operational 100M, Maximum 1G Duplex: Admin Auto, Operational Full Active-medium: Copper Switchport settings: access, access-vlan: 10 IP-Address: unassigned, primary Input packets 8900, bytes 887098, dropped 0, Received 6106 broadcasts, 0 multicasts Input errors 0, runts 0, giants 0, CRC 0, frame 0, fragment 0, jabber 0 Output packets 25504, bytes 3134441, dropped 0 Sent 21 broadcasts, 23115 multicasts Output errors 0, collisions 0, late collisions 0, Excessive collisions 0 RFS7000(config)# RFS7000(config)#show interfaces ge 1 Interface ge1 Hardware Type Ethernet, Interface Mode Layer 2, address is 00-15-70-37-fc-8f index=2001, metric=1, mtu=1500, (HAL-IF) Speed: Admin Auto, Operational Unknown, Maximum 1G Duplex: Admin Auto, Operational Unknown Active Medium: Unknown Switchport Settings: Mode: Access, Access Vlan: 1 input packets 0, bytes 0, dropped 0, multicast packets 0 input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0, missed 0 output packets 0, bytes 0, dropped 0 IFNAME Interface name. ge <1-4> GigabitEthernet interface. Select an index value between 1- 4. me1 <> FastEthernet interface. sa <1- 4> StaticAggregate interface. Select an index value between 1- 4. switchport () Status of Layer2 interfaces. Select from the following L2 interfaces: • ge – GigabitEthernet interface. • me1 – FastEthernet interface. • sa – StaticAggregate interface. • tunnel – Tunnel interface. • vlan – VLAN. vlan <1-4092> VLAN interface. Select an index value between 1- 4092.