Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 275)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 261
53-1001945-01
Chapter
8
Crypto-peer Instance
In this chapter
• Crypto Peer Config Commands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 261
Use
crypto isakmp( peer)[IP Address|dn|hostname]
to initiate
config-crypto-peer
instance.
Crypto Peer Config Commands
The following table summarizes the
config-crypto-peer
commands within the Brocade Mobility
RFS7000-GR Controller command line interface.
TABLE 5 Crypto Peer config commands
Command Description Ref.
clrscr Clears the display screen. page 262
end Ends the current mode and moves to EXEC mode. page 263
exit Ends the current mode and moves to the previous mode. page 264
help Displays the interactive help system. page 265
no Negates a command or set its defaults. page 266
service Displays service commands. page 267
set Sets the configuration. page 268
show Shows running system information. page 269