Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 351)

Brocade Mobility RFS7000-GR CLI Reference Guide 337
53-1001945-01
Chapter
13
Spanning tree-mst Instance
In this chapter
• mst Config commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 337
• Configuring Interface using MSTP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 349
Use the
(config-mst
) instance to configure the Multi Spanning Tree Protocol (MSTP). Use the
command
spanning-tree mst configuration
to instantiate this instance.
mst Config commands
The following table summarizes the
config-mst
commands.
Table 13.3 mst config commands
Command Description Ref.
clrscr Clears the display screen. page 338
end Ends the current mode and moves to the EXEC mode. page 339
exit Ends the current mode and moves to the previous mode. page 340
help Describes the interactive help system. page 341
instance Assigns a VLAN to the bridge instance. page 342
name Sets a name for the MST region. page 343
no Negates a command or sets defaults. page 344
revision Configures the revision number of the MST bridge. page 345
service Displays service commands. page 346
show Shows running system information. page 348