Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 582
568
Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
RTLS Config Commands
21
no
Use this command to negate a RTLS command or set its defaults.
Syntax
no [aeroscout|ekahau|reference-tag|service|site|
switch|ap|zone]
Parameters
Usage Guidelines
Use
no
command to undo the configurations on the parameters mentioned in the table. Refer to
the parameters, within this chapter, for complete syntax.
Example
RFSwitch(config-rtls)#no aeroscout enable
RFSwitch
RFSwitch(config-rtls)#no ekahau enable
aeroscout [enable|
multi-cast-listen|addr]
Negates aeroscout configuration
•
enable – Disable SOLE adapter
•
multicast-listen-addr– Configure multicast listening address
ekahau [enable|engine|multicast]
Negates ekahau configuration
•
enable – Disable aeroscout external engine
•
engine –reset external location engine parameters
•
multicast-listen-addr– Configure multicast listening address
reference-tag
Negates reference-tag configuration
service [filter <1-100> {length|
memory-bank|offset
}|inventory {<1-100>|default]
Negates service configuration for:
•
filter <1-100> {length|memory-bank|offset} – Negates RFID tag filter
configuration for the selected index
•
length – Length of tag filter
•
memory-bank – Tag memory bank
•
offset – Offset into the tag memory bank
•
inventory [<1-100>|default] – Negates tag inventory for the selected
index or the default index
•
filter – Configures tag filter for inventory
•
start – Starts tag inventory
•
start-trigger – Removes start trigger for tag inventory
•
stop-trigger – Removes stop trigger for tag inventory
•
zone – Configures logical reader
site
Negates site configuration
zone<1-48>
Negates zone configuration
ap [MAC Address
•
AA-BB-CC-DD-EE-FF – Disables access port MAC IP address
•
coordinates – Negates AP location configuration
switch [coordinates
|geo-coordinates]
•
Negates switch configuration parameters
•
coordinates – Negates switch coordinates configuration within the site
•
geo-coordinates – Negates switch geo coordinates configuration