Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 399)

Brocade Mobility RFS7000-GR CLI Reference Guide 385
53-1001945-01
Chapter
16
Extended MAC ACL Instance
In this chapter
• MAC Extended ACL Config Commands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 385
Use the
(config-ext-macl)
instance to configure
mac access-list extended
ACLs associated
with the switch.
Use a decimal value representation of ethertypes to implement
permit/deny/mark
packet. The
command set for Extended MAC ACLs provides hexadecimal values for each of its listed ethertypes.
The switch supports all ethertypes. Use the decimal equvilant of the ethertype listed in the CLI for
any other ethertype.
MAC Extended ACL Config Commands
The following table summarizes the
config-ext-macl
commands.
TABLE 12 MAC Extended ACL config commands
Command Description Ref.
clrscr Clears the display screen. page 386
deny Specifies packets to reject. page 387
end Ends the current mode and changes to EXEC mode. page 389
exit Ends the current mode and moves to the previous mode. page 390
help Displays the interactive help system. page 391
mark Specifies packets to mark. page 392
no Negates a command or set its defaults. page 394
permit Specifies packets to forward. page 395
service Displays service commands. page 397
show Shows the running system information. page 398