Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 204)

190 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Global Configuration Commands
5
interface
Global Configuration Commands
Use this command to configure a selected interface. This command is used to enter the interface
configuration mode for the specified physical/ Switch Virtual Interface (SVI) interface. If the VLANx
(SVI) interface does not exist, it is automatically created.
NOTE
The interface mode leads to the
config-if
instance. For additional information, see Interface
Instance on page 311 .
The prompt changes from
RFS7000(config)#
to
RFS7000(config-if)#
Syntax
interface(IFNAMEWORD|fe|ge <1-4>|sa <1-4>|vlan <1-4094>)
Parameters
Usage Guidelines
Use
[no] interface
to delete the specified SVI. Valid interfaces include all
VLANx interfaces.
Example
RFS7000(config)#interface me1
RFS7000(config-if)#
RFS7000(config)#interface ge 3
RFS7000(config-if)#
RFS7000(config)#interface sa 2
RFS7000(config-if)#
RFS7000(config)#interface vlan 400
RFS7000(config-if)#
IFNAMEWORD Interface name.
ge <1-4> GigabitEthernet interface. Select an index value between 1 - 4.
me1 FastEthernet interface.
sa <1- 4> StaticAggregate interface. Select an index value between 1 - 4.
vlan <1-4092> VLAN interface. Select an index value between 1 - 4092.