Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 586)

572 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
RTLS Config Commands
21
Parameters
Usage Guidelines
Use [no] service [options] to rollback any service related configurations.
Example
RFSwitch(config-rtls)#service filter 1 length 1
RFSwitch(config-rtls)#
ap Access port coordinate configuration.
•
– Acces port MAC address.
service filter <1-100>
[action|length <1-128>|mask|
memory-bank|name|offset<0-32>] Configures RFID tag filter
•
action [allow|deny] – Configures action for tag filter. By default its
configured to allow
•
length <1-128> – Configures number of bits to compare against tag
mask
•
mask – Configures tag mask for filter
•
memory-bank [epc|tid|uid] – Configures tag memory bank for the filter
•
epc – EPC memory bank
•
tid – TID memory bank
•
uid – UID memory bank
•
name – Configures tag filter name
•
offset <0-32> – Configures first location of memory bank against which
the tag mask is compared
rtls (mode) Shows rumnning information.
•
mode {auto|presence|trilateration}– Sets rlts mode.
•
auto – Sets auto mode.
•
presence – Sets presence-only mode.
•
trilateration – Sets trilateration-only mode.
show cli Show running system information
•
cli – Show CLI tree of current mode