Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 552)

538 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
enhanced-beacon-table
[channel-set|enable|
erase-report|max-ap|
scan-interval|scan-time] Enhanced beacon table for AP locationing.
•
channel-set – Channel set for Enhanced Beacon Table.
•
a <1-200> – Add channels to channel-set for Enhanced Beacon Table for
802.11a radios.
•
an <1-200> – Add channels to channel-set for Enhanced Beacon Table for
802.11an radios.
•
bg <1-200> – Add channels to channel-set for Enhanced Beacon Table for
802.11bg radios.
•
bgn <1-200> – Add channels to channel-set for Enhanced Beacon Table
for 802.11bgn radios.
•
<1-200 > – List of space separated channel number(s) between 1 and
200.
•
enable – Enables Enhanced beacon table for AP locationing.
•
erase-report – Erases the enhanced beacon table for AP locationing report.
•
max-ap <0-512> – The number of APs in the enhanced beacon table for AP
locationing.
•
scan-interval <10-60> – The time duration between two enhanced beacon
table for AP locationing scans in seconds.
•
scan-time <100-1000> – The time duration of an Enhanced Beacon Table scan
in milliseconds.
enhanced-probe-table
[enable|erase-report|max-m
u|preferred|
window-time] Enhanced probed table for MU locationing.
•
enable – Enables enhanced probe table for MU locationing.
•
erase-report – Erases the enhanced probe table for mu locationing report.
•
max-mu <0-512> – Maximum number of MUs in the report.
•
preffered _– Adds the given mac to the preferred MU
list.Specify the MAC address in AA-BB-CC-DD-EE-FF format.
•
window-time <10-60> – Window time for probe collection in seconds.
forward-eap-to-wired Forwards EAP packets from a mobile-unit to the wired side for the wired switch to
perform 802.1x authentication.
NOTE: Does not apply for EAP frames directed to the BSS for wireless 802.1x EAP
Authentication
free-packet-watermark
<0-100> Free packets threshold.The watermark percentage range is <0-100>.
If the percentage of free packets is lower than this number, then additional packets
will not be queued up in the datapath.
idle-radio-send-multicast
(enable) Forward multicast packets to radios without associated mobile units.
•
enable – Enables multicast forwarding.
legacy-load-balance Invoke legacy load balance algorithm with The Brocade Mobility RFS7000-GR
Controller.
map-radios <1-127> Sets radio-to-cpu mapping constants.
<1-127> – radio-to-cpu mapping constant.
radio-mic-cfg This command is used for radio specific miscellaneous configuration – U16 for all
radios.
rate-scale Enables wireless rate scaling (default).
request-ap-log <1-256> Requests an access port log for the selected access port. Select an access port
index between 1 - 256.
rogue-find-range <1-10> Sets rogue search range. <1-10> is the numeric range.
save-ap-log Saves debug/error logs sent by the access port.