Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 84)

70 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
show
2
redundancy-group
Common to all modes
This command displays the switch’s IP address, number of active neighbors, group license,
installed license, cluster AP adoption count, switch adoption count, hold time, discovery time,
heartbeat interval, cluster id, switch mode etc.
In a cluster, this command displays the redundancy runtime and configured information of the
self-switch. Use
config
parameter to view only configuration information and/or
runtime
parameter to view runtime information.
Syntax
show redundancy-group [dynamic-ap-load-balance (config)|group
(config|runtime)|history|member|] config|runtime]
Parameters
Example
RFS7000(config)#show redundancy members brief
Member ID (Self) : 0.0.0.0
Member State : Not Applicable
RFS7000(config)#
RFS7000(config)#show redundancy dynamic-ap-load-balance config
Dynamic AP Load Balance Configuration:
Load balance : Disabled
Load balance trigger : Schedule
Dynamic AP Load Balance Schedule:
Schedule first-time : Sun Jun 1 00:00:00 2008
Schedule interval : 1 day(s)
dynamic-ap-load-balance
config Displays redundancy group information.Display redundancy dynamic AP load
balance parameters
config Display configuration details for dynamic AP Load Balance
group Display redundancy group parameters
config Display configured redundancy group information.
runtime Display runtime redundancy group information.
history Display state transition history of the switch.
members Display redundancy group members in detail
A.B.C.D IP address of member switch
brief Display members in brief
runtime Displays runtime redundancy group information.