Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 565)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 551
53-1001945-01
Wireless Configuration Commands
20
hotspot((allow-list|allow-list
|
cache-ageout|connection-m
ode|
ntf-logout-port|query|redire
ct-to-hostname|
simultaneous-users|webpag
e|webpage-location)) Modifies hotspot related parameters.
•
allow-eap – Allows EAP authentication in addition to web basedlogin.
•
allow-list (rule index) <1-32>(IP address) – Modifies hotspot allow-list
parameters. Users who have not yet authenticated must be allowed access to
these IP addresses.
•
Rule index<1-32> – Allow-list Rule index (must be between (1-10)32).
•
IP address – Allow-list IP address.
•
cache-ageout <5-86400> – Configures hotspot cache-ageout
•
<5-86400> – Time in seconds to age out the cache after mu
disassociation.
•
connection-mode – Use the type of connection mode as https.
•
ntf-logout-port – Configures port to send NTF-Logout in web-portal mode
hotspot.
•
<0-65535> – select a porta in the range of 1-65535, or 0 to use original
source port in req-challenge.
•
query <1-10> |QUERY –Sspecifies queries to be appended to redirection url.
•
<1-10> – A single index.
•
QUERY – A list (eg: 1,3,7) or range (eg: 3-7) of indices.
•
redirect-to-hostname – Use the hostname/System-Name in the redirection URL
instead if the IP address of the switch.
•
simultaneous-users <0-8192> – Enforces that a particular username can only
be used by certain number of MAC addresses at a time.
•
<0-8192> –The number of MAC addresses that are allowed to use that
username at the same time. 0 implies disabling of the checks.
•
webpage (external|internal) (failure|login|welcome) – Modifies hotspot page
parameters.
•
external – Modifies a hotspot’s External page.
•
internal – Modifies hotspot’s Internal page.
•
failure – Users are redirected to this Web page if they fail authentication.
•
login – Users are prompted for their username and password within this
Web page.
•
welcome – Users are redirected to this Web page after they authenticate
successfully.
•
webpage-location (advanced|external|internal) – The location of the Web
pages used for authentication. These pages can either be hosted on the switch
or an external Web Server.
•
advanced – Uses login/welcome/failure Web pages created by the user on
the switch.
•
external – Uses login/welcome/failure Web pages on an external server.
•
internal – Use login/welcome/failure Web pages created automatically on
the switch.
inactivity-timeout
<60-86400> Inactivity timeout in seconds. If a frame is not received from a mobile unit for this
interval, the mobile unit is disassociated.
independent Sets this wlaln to be an independent wlan.
ip [arp|dhcp] Internet Protocol
•
arp {rate-limit|trust} – arp
•
dhcp (trust) – dhcp
•
rate-limit <1-1000000> – Does packet ratelimiting.
•
<1-1000000> – Allowed rate in packets/sec.
•
trust – Trust arp responses on this wlan/range of wlans